This drawing shows the plumbing of an Elevated Water Feature where the Filtrific filter tank can be placed lower that the water level of the water feature. Position the T75F filter tank at a convenient location, either buried or above ground. Ensure its accessible for maintenance. Connect the intake port to the water feature’s main water source. The T75F can handle flow rates up to 200 GPM (12,000 GPH). Install up to four pumps in the spacious pumping chamber. Use the front and back discharge ports for pump connections. Place the S5 skimmer at the water feature’s surface level to effectively remove debris. Connect the skimmer’s output to the T75F filter tank’s intake port. This ensures that water is pre-filtered before entering the main filter tank. Install the UV57 filter in line with the plumbing system, ideally after the T75F filter tank. Connect the output of the T75F filter tank to the input of the UV57 filter. This setup ensures that water is treated for harmful microorganisms before being circulated back into the water feature. Position the UCC-2 up circulator at the desired location within the water feature to create the desired water movement. Connect the circulator to the output of the UV57 filter. This ensures that clean, treated water is circulated throughout the water feature. Once all components are connected, test the system to ensure proper water flow and filtration. Make any necessary adjustments to the pump settings and connections to optimize performance. Regularly check and clean the skimmer, filter tank, and UV filter to maintain efficient operation. By following these steps, you can create a well-functioning elevated water feature with effective filtration and circulation using Filtrific components.